- Project plans
- Project activities
- Legislation and standards
- Industry context
Last edited 20 Sep 2018
Condensation in buildings
When air cools, it is less able to 'hold' moisture, that is, the saturation water vapour density falls, and so the relative humidity rises. When the relative humidity reaches 100%, the air will be saturated. This is described as the dew point. If the air continues to cool, moisture will begin to condense.
Condensation can occur on surfaces, or can be interstitial condensation occurring between the layers of the building envelope, typically as a result of air diffusing from the warm interior of the building to the cool exterior and reaching its dew point within the building fabric. This interstitial condensation, when trapped within the structure by impervious materials is often erroneously referred to as rising damp.
- Mould growth which is a cause of respiratory allergies.
- Slip hazards.
- Damage to equipment.
- Corrosion and decay of the building fabric.
- Poor performance of insulation (see Insulation specification for more information).
Condensation can be controlled by:
- Limiting sources of moisture (including reverse condensation, where moisture evaporates from damp materials). For example, replacing flueless gas or oil heaters.
- Increasing air temperatures.
- Natural or mechanical ventilation. This is particularly important in cold roofs, where unseen problems can build up, putting occupants in danger of structural collapse.
- Increasing surface temperatures, such as by the inclusion of insulation or by improving glazing.
- Avoiding cold bridges. These are situations where there is a direct connection between the inside and outside through one or more elements that are more thermally conductive than the rest of the building envelope. Thermal bridges are common in older buildings, which may be poorly constructed, poorly insulated, with single skin construction and single glazing. In modern buildings, thermal bridging can occur because of poor design, or poor workmanship. This is common where elements of the building penetrate through its insulated fabric, for example around glazing, or where the structure penetrates the building envelope, such as at balconies.
- The introduction of vapour barriers (vapour control layers) which prevent moisture from diffusing through the building fabric to a point where temperatures might be low enough to reach dew point.
It is important that any systems introduced to limit condensation are properly installed and maintained to ensure continued optimal operation.
Condensation in buildings is regulated by Approved Document C (Site preparation and resistance to contaminates and moisture) and Approved Document F (Ventilation) and further guidance is available in BS 5250 Code of practice for the control of condensation in buildings.
 Related articles on Designing Buildings Wiki
- Approved Document F.
- Cold bridge.
- Damp proofing.
- Designing out unintended consequences when applying solid wall insulation FB 79.
- Dew point.
- Diagnosing the causes of dampness (GR 5 revised).
- Dry-bulb temperature.
- Interstitial condensation.
- Mould growth.
- Penetrating damp.
- Psychometric chart.
- Rising damp.
- Sling psychrometer.
- Treating brickwork with sealant or water repellent.
- Water vapour.
- Wet-bulb temperature.
Featured articles and news
Brokenshire launches an implementation plan for the recommendations made by Dame Judith Hackitt.
BSRIA publication provides guidance about the capture and analysis of big data.
Gove launches a waste and resources strategy for England.
Only 9% of construction workers are 24 or younger.
Blighting local areas, preventing investment and and encouraging anti-social behaviour.
Sharing knowledge about the conservation of the built and historic environment.
CIOB launches a call to improve quality in the built environment.
Vastint gets permission for a 6.6 hectare site to support the expansion of Leeds’ city core.
One of the Isle of Man’s best 1960s buildings.
Using renewable energy in developing countries - QSAND and Loughborough University Research collaboration.
From frost damage to sulphate attack, common causes of defects in brickwork.