- Project plans
- Project activities
- Legislation and standards
- Industry context
Last edited 15 Feb 2018
Ground beams in construction
Ground beams are generally constructed from concrete, and for low-rise buildings are commonly constructed in situ, however, as this can be relatively time-consuming method, the use of precast concrete ground beams has increased.
The advantages of using ground beams are that they are quicker to install than conventional footings, and allow uncertainties regarding ground conditions to be overcome. They also create a very accurate bearing level, reducing the amount of levelling up that is required prior to starting to build up the superstructure.
Ground beams may be used to support brick work, block work and so on, but may also be used at the edge of in situ concrete floor slabs, where they form permanent shuttering. They tend to be square or rectangular in section, and can be designed to incorporate notches, end details and sloping faces.
Precast ground beams are cast to the required lengths in an off-site factory and are then lowered into place on site, typically spanning between the tops of piles. Small in situ concrete ‘stitches’ are used to connect and bolt the beams securely to each other and the piles. Secondary beams can also be connected to the ground beam system to form a beam and block ground floor.
 Related articles on Designing Buildings Wiki
Featured articles and news
The quality of Cambridge owes as much to its open spaces as to its architectural uniqueness.
If events occur that cause the completion of the works to be delayed then these may be compensation events.
BSRIA's new Building MOTs Scheme is designed to provide guidance on the next steps after compliance.
At an ICE discussion, the focus was on delivering a Northern Infrastructure Strategy based on opportunity for all.
The Considerate Constructors Scheme officially launch the new Ultra Site status for contractors and supply chains.
The risk of specification errors in the cladding sector is "worryingly high" after Grenfell, according to major distributor.
Here is our outline work plan for a private sector design and build project.
BRE are to publish new guidance aimed at assuring buyers as to the merits of off-site construction methods.
Who are the various different stakeholders in development projects? Find out in our introductory article.
How a BRE office became the centre-piece for major biophilic design research.