Deflection
[edit] Introduction
Deflection – in engineering terms – is the degree to which an element of structure changes shape when a load is applied. The change may be a distance or an angle and can be either visible or invisible, depending on the load intensity, the shape of the component and the material from which it is made.
Deflection is a crucial consideration in the design of a structure and failure to apply due attention to it can be catastrophic.
Different types of load can cause deflections. These include point loads, uniformly distributed loads, wind loads, shear loads as well as ground pressure and earthquakes, to name but a few. When a load produces a deflection that is too great, the component may fail.
Components and structures that suffer deflection include, beams, columns, floors, walls, bridge decks, tunnel walls, dams and so on. San Francisco’s Golden Gate Bridge can sway by as much as 4m laterally under strong winds.
Non-structural components can also deflect, for example cladding panels on a building may deflect inwards when subject to intense wind loading.
Given the possibility of structural failure, building codes usually determine what the maximum allowable deflection should be to ensure the safety of a building’s users and overall structural integrity. For a beam, this is usually expressed as a fraction of the span, eg the beam’s deflection should not be greater than 1/360th of the span; so, if the span is 5m, the deflection should not be greater than 13.9mm. This will usually be measured at the mid-point of the beam.
A structural element will deflect less under load if its stiffness or rigidity is increased. This can usually be achieved by strengthening its section or increasing its size; the latter may also increase its cost.
The material itself must also be considered. For example, because aluminium is around three times more flexible than steel, it is often designed for deflection rather than strength. In contrast, glass is relatively inflexible: even slight deflections in a steel frame could cause the glass to fracture.
[edit] Related articles on Designing Buildings Wiki
- Approved Document A.
- Concept structural design of buildings.
- Elements of structure in buildings
- Institution of Structural Engineers IStructE.
- Span.
- Structural principles.
- Structures at the end of their design life.
- Substructure.
- Superstructure.
- The development of structural membranes.
- Tower.
- Types of structure.
Featured articles and news
Our next guest editor Christine Peever
Practising Architect and Director of Sheldon Peever Studio.
Biodiversity net gain, tips and tools for small sites
How to deal with BNG when options become limited.
Registered building inspectors
Building types and conflicts of interest updates explained.
A brief run-down reminder of key points to note.
New electrical apprentice rates
Fair pay for much needed pipeline of electrical apprentices.
BSRIA's commitment to sustainability and net zero
Key documents that represent an early shift in thinking.
A resource for Cleaner Air, Better Tomorrow.
Awe-inspiring medieval great barns.
A history of timber construction in the UK
From a timber Stonehenge to half timber houses.
Engineering services still struggle with labour shortages
According to latest quarterly services survey of the sector.
Infrastructure that connect the physical and digital domains.
BSRIA announces Lisa Ashworth as new CEO
Tasked with furthering BSRIA’s impressive growth ambitions.
Public buildings get half a million energy efficiency boost
£557 million to switch to cleaner heating and save on energy.
CIOB launches pre-election manifesto
Outlining potential future policies for the next government.
Grenfell Tower Inquiry announcement
Phase 2 hearings come to a close and the final report due in September.