Coupled loads
Coupled loads are less common in buildings but may be relevant in some cases, they describe equal but opposite forces that might act on the same span, resulting in turning or spin if not in balance. For example if on one side of a beam a downward force is applied and on the other side of a beam an upward force of the same amount is applied, the loads are referred to as coupled loads.
[edit] Related articles on Designing Buildings
- Bearing capacity.
- Beam and block.
- Biaxial bending.
- Braced frame.
- Concept structural design of buildings.
- Dead loads.
- Finished floor level.
- Flooring.
- Gross floor area GFA.
- Lateral loads.
- Limit state design.
- Live loads.
- Load-bearing wall.
- Point load.
- Resilient flooring.
- Structural engineer.
- Types of floor.
- Types of structural load.
- Uniformly Distributed Load.
- Wind load.
Featured articles
Check out some of the best features and news from Designing Buildings as well as key stories from around the web.
The Building Safety Regulator announces a call for evidence.
Government approach could undermine delivery and regeneration.
World's first mass timber data centre.
The overlooked environmental aspect of data centre development.
Introduction to radon awareness
New technical information sheet published by CIOB.
Updated supplier guide can help electrical contractors engage with NHP.
CIAT confirm the winners of the 2026 architectural technology awards.
Government launches a one stop shop for flood preparedness.
Sir Edwin Lutyens: Britain's greatest architect? Book review.
CIOB publishes free template to help assess and manage risks.
ECA's reflections on Party Conference season
Burnham wants to be confident of winning before asking for a fresh mandate.
New Chief Construction and Scientific Adviser
Sergio Cavalaro, Professor of Infrastructure Systems at Loughborough University.
Building safety levy for England
CIAT publish estimator tool for members.
Comments
[edit] To make a comment about this article, or to suggest changes, click 'Add a comment' above. Separate your comments from any existing comments by inserting a horizontal line.