Coupled loads
Coupled loads are less common in buildings but may be relevant in some cases, they describe equal but opposite forces that might act on the same span, resulting in turning or spin if not in balance. For example if on one side of a beam a downward force is applied and on the other side of a beam an upward force of the same amount is applied, the loads are referred to as coupled loads.
[edit] Related articles on Designing Buildings
- Bearing capacity.
- Beam and block.
- Biaxial bending.
- Braced frame.
- Concept structural design of buildings.
- Dead loads.
- Finished floor level.
- Flooring.
- Gross floor area GFA.
- Lateral loads.
- Limit state design.
- Live loads.
- Load-bearing wall.
- Point load.
- Resilient flooring.
- Structural engineer.
- Types of floor.
- Types of structural load.
- Uniformly Distributed Load.
- Wind load.
Featured articles
Check out some of the best features and news from Designing Buildings as well as key stories from around the web.
CIOB announces Saul Humphrey FCIOB as new President for 26/27 term.
A quick, simple, and zero-bills solution to prevent overheating.
The adaptive reuse of large industrial structures.
Promoting the circular economy by extending the life of buildings.
CIAT responds to Climate Change Committee report
An urgent wake-up call for both government and the built environment.
Construction Management, 24 June
FMB pilot aims to build pipeline of site-ready tradespeople.
A quick introduction.
CLC publishes Mental Health Joint Code of Practice.
A quick introduction to its uses and risks.
Construction Management, 17 June
Government rolls out digital planning tool to all local authorities.
Your views needed - a strategy for the professions, trades and occupations.
Confronting competency, codes, capacity and costs.
The hidden risk in modern construction supply chains.
Comments
[edit] To make a comment about this article, or to suggest changes, click 'Add a comment' above. Separate your comments from any existing comments by inserting a horizontal line.