- Project plans
- Project activities
- Legislation and standards
- Industry context
Last edited 19 Mar 2018
See also: How to design a pad foundation.
See also: Types of pad foundation.
Foundations provide support for structures, transferring their load to layers of soil or rock that have sufficient bearing capacity and suitable settlement characteristics. They can be used to help to prevent settlement and other movements of structures and can permit construction on ground that might otherwise have insufficient bearing capacity.
There are a very wide range of foundation types suitable for different applications, depending on considerations, such as:
- The nature of the load requiring support.
- Ground conditions.
- The presence of water.
- Sensitivity to noise and vibration.
- Proximity to other structures.
- Project time-frames.
Very broadly, foundations can be categorised as shallow foundations or deep foundations. Shallow foundations are typically used where the loads imposed by a structure are low relative to the bearing capacity of the surface soils. Deep foundations (more than 3 m from the surface) may be necessary where the bearing capacity of the surface soils is insufficient to support loads imposed.
Pad foundations are generally shallow foundations, but can be deep depending on the ground conditions. They are a form of spread foundation formed by rectangular, square, or sometimes circular concrete ‘pads’ that support localised single-point loads such as structural columns, groups of columns or framed structures. This load is then spread by the pad to the bearing layer of soil or rock below. Pad foundations can also be used to support ground beams.
They are generally of a uniform thickness, but sometimes the upper face may be sloped or stepped. Their plan shape will depend on the nature of the applied load and the allowable bearing capacity of the layers below. Their thickness must be sufficient to distribute the load across the plan shape. They are generally reinforced on all but the smallest structures, with the reinforcement allowing higher loads to be imposed and the construction of shallower pads which require less excavation and use less concrete.
The arrangement of pad foundations will vary depending on the nature of the structure they are supporting, the loads imposed, the allowable bearing capacity of the layers below and the space available on site. They may be:
- A series of discrete, well-separated pads.
- Balanced base pads that support more than one point load.
- Continuous pads, where there are a number of point loads close together.
- Pad and beam, where a series of pads support a continuous beam.
Pad foundations can be selected as they do not require much excavation, and are generally suitable where the bearing capacity of ground is sufficient at relatively low depths. However, they can be large in plan shape and may not be effective against differential settlement, uplift forces or wind forces.
 Related articles on Designing Buildings Wiki
- Compensated foundation.
- Continuous flight auger piles.
- Driven piles.
- Geothermal pile foundations.
- Ground anchor.
- How deep should foundations be?
- How to design a pad foundation.
- Pile foundations.
- Raft foundation.
- Screw piles.
- Strip foundation.
- Temporary works.
- Trench fill foundation.
- Types of pad foundation.
- Types of raft foundation
Featured articles and news
EIRs define what is needed from the employer's internal team and suppliers for project development.
The full keynote speech by Sir James Bevan, Environment Agency CEO, on the future of flood protection.
After 6 years, the Metropolitan Police admit they supplied information to the construction workers blacklist.
It's nearly two years since level 2 BIM was made a minimum requirement on certain public projects. But what actually is it?
Renowned water expert Prof. Martin van Veelen challenges political leaders to do more on safe and clean water supplies.
Inquiry criticises PwC for "milking the Carillion cow dry".
A recent roundtable discussed the future of transport in the UK – including the role of connected and autonomous vehicles.
Architects report cancelled projects and uncertainty concerns in a new RIBA survey on Brexit.
Quality helps eliminate defects, but it can also drive improvement and increase profit.
PII provides insurance cover against negligence claims and is widely used where services are being provided.
Rogers Stirk Harbour + Partners release first images of their planned new addition to the Toronto skyline.