Approved Document P
The building regulations establish standards that must be achieved in the construction of buildings.
Part P of Schedule 1 to the Building Regulations requires that, ‘Reasonable provision shall be made in the design and installation of electrical installations in order to protect persons operating, maintaining or altering the installations from fire or injury.’
This applies to electrical installations intended to operate at low or extra-low voltage, that are:
- In or attached to a dwelling.
- In the common parts of a building serving one or more dwellings, but excluding lifts.
- In a building that receives its electricity from a source located within or shared with a dwelling.
- In a garden or in or on land associated with a building where the electricity is from a source located within or shared with a dwelling.
In order to meet this requirement, low voltage and extra-low voltage electrical installations in dwellings must be designed and installed to give appropriate protection against mechanical and thermal damage and not to present electric shock and fire hazards to individuals.
A series of Approved Documents set out what typically would be acceptable for compliance with the relevant requirements of Building Regulations. There is no legal obligation to follow the guidance in the Approved Documents.
Approved Document P - Electrical safety – Dwellings, describes methods for ensuring compliance with the electrical safety requirements for homes in relation to Part P of the Building Regulations. The most recent edition was published in January 2013 and came into effect in April 2013. It replaced Approved Document P (2006) which incorporated 2010 amendments. The main changes brought in by the 2013 edition included:
- A reduction in the range of the electrical installation work that is notifiable to a building control body.
- Installers not a registered a competent person are permitted to use a 'registered third-party certifier' to certify work, as an alternative to a using building control body.
- The technical guidance refers to BS7671:2008 Requirements for Electrical Installations, incorporating Amendment No 1:2011.
The content of the Approved Document includes:
- Section 1: Design and installation - There is a general requirement that electrical installations should be designed and installed in accordance with BS7671:2008.
- Section 2: Application of Part P – This section covers the types of buildings and installations that are covered by the Scope of Part P and the types of work that are notifiable and must be certified as complying with Building Regulations.
- Section 3: Certification, inspection and testing – Certification of notifiable installations is required, along with inspecting and testing in accordance with BS7671.
- Appendix A: Key terms.
- Appendix B: Standards referred to.
Parts A, B, C, E, F, L and M of the Building Regulations also contain provisions relating to electrical installations.
[edit] Related articles on Designing Buildings
- 2021 PRS electrical safety standards.
- Approved documents.
- Approved inspector.
- BS 7671.
- Building control body.
- Building notice.
- Building regulations.
- Competent person schemes.
- Electrical contractor.
- Electrical engineer.
- Electrical safety.
- Electrician.
- Glossary of electrical terms.
- Low voltage.
- Mechanical and electrical.
Featured articles and news
Shading for housing, a design guide
A look back at embedding a new culture of shading.
The Architectural Technology Awards
The AT Awards 2025 are open for entries!
ECA Blueprint for Electrification
The 'mosaic of interconnected challenges' and how to deliver the UK’s Transition to Clean Power.
Grenfell Tower Principal Contractor Award notice
Tower repair and maintenance contractor announced as demolition contractor.
Passivhaus social homes benefit from heat pump service
Sixteen new homes designed and built to achieve Passivhaus constructed in Dumfries & Galloway.
CABE Publishes Results of 2025 Building Control Survey
Concern over lack of understanding of how roles have changed since the introduction of the BSA 2022.
British Architectural Sculpture 1851-1951
A rich heritage of decorative and figurative sculpture. Book review.
A programme to tackle the lack of diversity.
Independent Building Control review panel
Five members of the newly established, Grenfell Tower Inquiry recommended, panel appointed.
Welsh Recharging Electrical Skills Charter progresses
ECA progressing on the ‘asks’ of the Recharging Electrical Skills Charter at the Senedd in Wales.
A brief history from 1890s to 2020s.
CIOB and CORBON combine forces
To elevate professional standards in Nigeria’s construction industry.
Amendment to the GB Energy Bill welcomed by ECA
Move prevents nationally-owned energy company from investing in solar panels produced by modern slavery.
Gregor Harvie argues that AI is state-sanctioned theft of IP.
Experimental AI housing target help for councils
Experimental AI could help councils meet housing targets by digitising records.
BSRIA Occupant Wellbeing survey BOW
Occupant satisfaction and wellbeing tool inc. physical environment, indoor facilities, functionality and accessibility.