Voltage sag
BSRIA Power quality guide (AG 2/2000) was written by C C Pearson and V Uthayanan and published by BSRIA in July 2000. It states:
A sag is a decrease to between 10% and 90% of nominal rms voltage or current at the fundamental frequency for durations from 0.5 cycles to one minute. Sags of longer than about 10 to 20 milliseconds may cause computer equipment to malfunction.
The power quality community has used the term sag for many years to describe a short-duration voltage decrease. Although the term has not been formally defined, it has been increasingly accepted and used by utilities, manufacturers, and end users. The IEC definition of this phenomenon is dip. The two terms are considered interchangeable.
Terminology used to describe the magnitude of a voltage sag is often confusing. A "20% sag" can refer to a sag which results in a voltage of 80% or 20%. The preferred terminology would be one that leaves no doubt as to the resulting voltage level: "a sag to 80%" or "a sag whose magnitude was 20%." When not specified otherwise, a 20% sag will be considered an event during which the rms voltage decreased by 20% to 80%. The nominal, or base, voltage level should also be specified.
Voltage sags are usually associated with system faults but can also be caused by energization of heavy loads or starting of large motors. They can be caused by an air conditioning (or other) motor starting or utility problems hundreds of miles away and may not be noticed by the naked eye. Some sensitive machines in a facility are affected (shut down) by voltage sags or the more severe interruptions. Voltage sags are usually far less costly to solve than interruptions, so it is important to monitor power circuits with equipment capable of capturing waveform information.
--BSRIA
[edit] Related articles on Designing Buildings
Featured articles and news
New President of ECA announced
Ruth Devine MBE becomes the 112th President of the Electrical Contractors Association.
New CIAT Professional Standards Competency Framework
Supercedes the 2019 Professional Standards Framework from 1 May 2025.
Difficult Sites: Architecture Against the Odds
Free exhibition at the RIBA Architecture Gallery until 31 May.
PPN 021: Payment Spot Checks in Public Sub-Contracts
Published following consultation and influence from ECA.
Designing Buildings reaches 20,000 articles
We take a look back at some of the stranger contributions.
Lessons learned from other industries.
The Buildings of the Malting Industry. Book review.
Conserving places with climate resilience in mind.
Combating burnout.
The 5 elements of seiri, seiton, seiso, seiketsu and shitsuke.
Shading for housing, a design guide
A look back at embedding a new culture of shading.
The Architectural Technology Awards
The AT Awards 2025 are open for entries!
ECA Blueprint for Electrification
The 'mosaic of interconnected challenges' and how to deliver the UK’s Transition to Clean Power.
Grenfell Tower Principal Contractor Award notice
Tower repair and maintenance contractor announced as demolition contractor.
Passivhaus social homes benefit from heat pump service
Sixteen new homes designed and built to achieve Passivhaus constructed in Dumfries & Galloway.
CABE Publishes Results of 2025 Building Control Survey
Concern over lack of understanding of how roles have changed since the introduction of the BSA 2022.