Lifts and Their Special Operating Modes
Contents |
Introduction
Lifts, whether residential or commercial, can operate in several special modes. These vary according to the needs of the users, which means, for example, a hospital lift will have a different operating mode to a lift in an office.
Medical emergency mode
Lifts with this mode are usually found in hospitals, where a rapid response is needed. The lifts need to be able to be summoned to any floor in an emergency, so each floor will have a recall key switch that, when activated, immediately selects the fastest lift – whether it is empty or carrying passengers.
When the lift arrives at a floor, it will remain there with its doors open. The buttons will be disabled to prevent ordinary passengers from controlling the lift. Medical personnel will active the key switch and the lift will travel uninterrupted to the desired floor.
Anti-crime protection mode
This special mode forces the lift to stop at a floor that was previously pre-defined. Building security can then inspect the passengers and loads being carried. Lifts with this mode can be found in many different buildings, but is particularly useful is properties that deal with financial transactions.
Sabbath service mode
This mode is only found in Sabbath lifts, which are common in areas with a large Jewish population. Lifts with this mode stop at every floor so that users do not have to press buttons. These lifts use a lot of energy, as the car needs to run up and down the building stopping at levels where it is not needed.
Fire service mode
This lift mode is activated when a fire occurs in a building, and it is used by firefighters. It can be found only in firefighter’s lifts or, depending on the country or location, in all lifts. Lifts designed to aid firefighters tend to have trap doors and ladders that make rescue operations easier. Electrical components are also protected against water.
In the UK, the fire service mode can be activated through a toggle switch, typically found in a small panel. Once activated the lift will go to the fire-recall floor and stop with its doors open. The lift will then remain unresponsive to further calls.
Firefighters can enable the lift to move again so that they can save people from a burning building. The lift will not open its doors unless firefighters wish it, to avoid opening the door to a room in flames.
Out of service mode
While this mode is usually used to signal a lift malfunction, it can also be used for other purposes, such as maintenance, cleaning, and energy-saving. This special lift mode can be found in many different lifts and is activated by a key switch or supervisory panel. When turned on, this mode stops the lift from working and will display an ‘Out of Service’ or ‘Park’ message. Lifts can also display a specific symbol or sign that indicate the same.
Peak times mode
There are two different special modes regarding peak times:
Up peak
Found in lifts that go through a moderate or considerable amount of traffic, typically in business areas. The mode works by sending lifts one by one until a pre-determined quota of passengers is met, or when doors have been opened for a while. A lift will return to the lobby and remain there whenever it is not in use. This mode can be programmed for rush hour if needed.
Down peak
When this mode is activated, lifts are sent from the lobby to several different floors, to answer calls of people leaving work. The same triggers apply here.
Conclusion
There are many different special operating modes of lifts, and some of them are dependent on location or country. Special modes add an element of safety to the lift and are useful in a wide range of unique circumstances.
Special modes of lifts also include emergency power operation, earthquake emergency return, and pet mode, typically seen in Japan, which once again shows that certain functions are only available in certain locations.
Related articles on Designing Buildings Wiki:
- Considerations When Installing a Residential Lift.
- Firefighting lift.
- Lifting platform.
- Lift motor room.
- Lift Standards: EN 81-20 and EN 81-50.
- Lifts and Escalators: A Quality Perspective.
- Lifts for Buildings.
- Lifts for office buildings.
- Lift shaft.
- Smart Elevators.
- The importance of service lifts.
- The science of lifts.
- The world's fastest lifts.
--Nathan Massey 14:16, 28 Nov 2016 (BST)
Featured articles and news
Permitted development rights for agricultural buildings
The changes coming into effect as of May 21, 2024.
Biodiversity and the built environment digital series
The nature of building, with CIOB and CWP.
A call for prevention and sensitive re-use.
Risks to the long-term effectiveness of the BNG scheme
National Audit Office publish review of Biodiversity Net Gain.
The CIAT principal designer register
Providing assurance and verification of the capability and competence of registered ATs.
Building Safety recommendations and Northern Ireland
The NI roadmap to improving safety in high rise residential.
Specifying rendered external wall insulation for fire safety
How to interrogate the evidence provided to the specifier.
The benefits of writing articles for your organisation
How to create a profile for your organisation and publish for free.
No Falls Week. The importance of safe working at height
What to expect and what is on offer to avoid accidents.
Scottish Government action to reach net-zero targets
Retrofit expert group highlight critical actions needed.
A forward thinking, inclusive global community of members.
From engineered product life-spans, to their extension.
Circular economy in the built environment
A brief description from 2021. Where are we now?
CLC publishes domestic retrofit competency framework
Roadmap of Skills for net zero.
Understanding is key to conservation.
Open industry engagement survey seeks responses
Institutions and the importance of engagement.
Comments