Designing Buildings at 06:14, 7 October 2020

2020-10-07T06:14:35Z

← Older revision		Revision as of 06:14, 7 October 2020
Line 75:		Line 75:
	* ‘Introduction to Civil Engineering Construction’ (3rd ed.), HOLMES, R., College of Estate Management (1995)		* ‘Introduction to Civil Engineering Construction’ (3rd ed.), HOLMES, R., College of Estate Management (1995)

−	[[Category:Construction_techniques]] [[Category:Design]]	+	[[Category:DCN_Guidance]] [[Category:Construction_techniques]] [[Category:Design]]

Designing Buildings at 14:02, 17 December 2018

2018-12-17T14:02:07Z

← Older revision		Revision as of 14:02, 17 December 2018
Line 56:		Line 56:
	* Bituminous mixing and laying plant.		* Bituminous mixing and laying plant.
	* Bridge construction.		* Bridge construction.
		+	* Construction sidings.
	* Ground conditions.		* Ground conditions.
	* Highway drainage.		* Highway drainage.

Editor at 15:37, 19 September 2017

2017-09-19T15:37:51Z

← Older revision		Revision as of 15:37, 19 September 2017
Line 1:		Line 1:
−	[[File:Runway.jpg]]	+	[[File:Runway.jpg\|link=File:Runway.jpg]]

	= Introduction =		= Introduction =
Line 62:		Line 62:
	* Overview of the road development process.		* Overview of the road development process.
	* Pavement.		* Pavement.
		+	* Railway engineering.
	* Road construction.		* Road construction.
	* Road joints.		* Road joints.

Editor: Created page with "File:Runway.jpg = Introduction = The construction of runways is similar to that of roads in that the type of pavement required depends on the loads needing to be carried, a..."

2016-06-13T13:47:51Z

Created page with "File:Runway.jpg = Introduction = The construction of runways is similar to that of roads in that the type of pavement required depends on the loads needing to be carried, a..."

New page

[[File:Runway.jpg]]

= Introduction =

The construction of runways is similar to that of roads in that the type of pavement required depends on the loads needing to be carried, although the stresses applied by aircraft can be very high and variable, up to 8 times greater than those on roads.

Pavements must facilitate safe aircraft ground operations, and in order to achieve this they must meet a number of performance requirements:

* Rideability.
* Good friction and drainage characteristics.
* Strength and stability sufficient to withstand shear stresses induced by heavy wheel loads and high tyre pressures.
* Durability.
* Resistance to fuel spillage and jet blast.
* Low maintenance requirements.

= Classifications =

Airfield pavements are designed to carry aircraft within certain one of two classifications, determined by the intensity of loads and stresses.

=== Load Classification Number – Load Classification Group (LCN-LCG) ===

This is used for UK military airfields. Each aircraft type is assigned a Load classification number (LCN) on a scale of 1 to 120. This reflects its relative effect on pavements and takes into account the weight of the aircraft as well as the specification of the undercarriage wheels. The LCN values are divided into seven Load classification groups (LCG) depending on their load-carrying capacity.

=== Aircraft Classification Number – Pavement Classification Number (ACN-PCN) ===

The relative loading severity of an aircraft on a pavement is expressed by one of 16 different values given to the aircraft, the Aircraft classification number (ACN). These represent the maximum and empty operating weights on rigid and flexible pavements for each of four different subgrade strengths.

The Pavement classification number (PCN) is used in combination with the ACN to indicate the strength the airfield pavement. It is recorded as a five-part code which corresponds to:

* LCN value.
* Type of pavement (rigid or flexible).
* Type of subgrade.
* Maximum tyre pressure for the pavement.
* How the strength assessment has been arrived at (technical design or experience-in-use).

= Pavement types =

Rigid pavements are commonly used for runway and taxiway junctions, aprons and hard-standings, and may be either reinforced or unreinforced pavement quality concrete (PQC). PQC is concrete that will provide a minimum flexural strength of 3.5 MN/m2 or more when the pavement is in use.

Composite pavements can also be used. Similar to road pavements, these consist of continuously reinforced concrete with a bituminous topping. The bitumen surface is usually asphalt and must have high stability and smooth-riding qualities.

Flexible pavements may be economical when used for light aircraft but otherwise will tend not to be appropriate.

Joints in concrete pavements are similar to those for concrete roads, although in a continuously reinforced slab there are no transverse joints. The reinforcement is lapped or welded to provide continuity.

=== Runway drainage ===

Runways must have excellent drainage capabilities as aircraft can aquaplane if there is just a thin film of water on the surface. The usual cross falls on the runway are 1 in 66. Cross falls on runway shoulders may be increased to 1 in 40. Gullies or drainage channels should also be provided.

On areas subject to fuel spillage, drainage should be channeled to a fuel and oil interceptor so that the water course is not polluted and to reduce the risk of fire. A single open trap located near the drainage outfall is usually provided.

= Find out more =

=== Related articles on Designing Buildings Wiki ===

* Bituminous mixing and laying plant.
* Bridge construction.
* Ground conditions.
* Highway drainage.
* Infrastructure.
* Kerbs.
* Overview of the road development process.
* Pavement.
* Road construction.
* Road joints.
* Tunnelling.
* Types of soil.
* Types of road and street.

=== External references ===

* Ministry of Defence – [https://www.gov.uk/government/uploads/system/uploads/attachment_data/file/33548/spec_33.pdf Pavement Quality Concrete for Airfields]
* ‘Introduction to Civil Engineering Construction’ (3rd ed.), HOLMES, R., College of Estate Management (1995)

[[Category:Construction_techniques]] [[Category:Design]]

Runway construction - Revision history

Designing Buildings at 06:14, 7 October 2020

Designing Buildings at 14:02, 17 December 2018

Editor at 15:37, 19 September 2017

Editor: Created page with "File:Runway.jpg = Introduction = The construction of runways is similar to that of roads in that the type of pavement required depends on the loads needing to be carried, a..."