Designing Buildings: Created page with "[https://www.bsria.com/uk/product/vBGLrE/bsria_power_quality_guide_ag_22000_a15d25e1/ BSRIA Power quality guide (AG 2/2000)] was written by C C Pearson and V Uthayanan and publis..."

2024-10-24T06:24:38Z

Created page with "[https://www.bsria.com/uk/product/vBGLrE/bsria_power_quality_guide_ag_22000_a15d25e1/ BSRIA Power quality guide (AG 2/2000)] was written by C C Pearson and V Uthayanan and publis..."

New page

[https://www.bsria.com/uk/product/vBGLrE/bsria_power_quality_guide_ag_22000_a15d25e1/ BSRIA Power quality guide (AG 2/2000)] was written by C C Pearson and V Uthayanan and published by BSRIA in July 2000. It states:

The required rating for the neutral conductor can be estimated using the typical waveforms. For a SMPS, the third harmonic is approximately 70% of the fundamental. If we assume that the loads on the three phases are balanced, as shown in Figure 30 and all have this same characteristic, then the rms phase current and rms neutral current can be approximated by taking only the fundamental, I1, and third harmonic,I3, components as follows:

[[File:Neutral conductor sizing for commercial loads 1.jpg]]

The neutral current in this case will be 172% of the rms phase current magnitude. The conclusion from this calculation is that neutral conductors in circuits supplying electronic loads should have almost twice the capacity of the phase conductors. An alternative method to wire these circuits is to provide a neutral conductor with each phase conductor.

[[File:Neutral conductor sizing for commercial loads fig 30.jpg]]

An approximate formula for calculating the neutral current magnitude as a percentage of the rms phase current is given below. The formula is based on the assumption that the circuit loading is balanced, that the nonlinear load watts are a fraction pnl of the total load, and that the load current has a third harmonic component equal to 70% of the fundamental.

[[File:Neutral conductor sizing for commercial loads 2.jpg]]

This relationship is illustrated in graphical form in Figure 31.

[[File:Neutral conductor sizing for commercial loads fig 31.jpg]]

--[[User:BSRIA|BSRIA]]

= Related articles on Designing Buildings =

* Alternating current and direct current
* Ampere.
* BSRIA articles on Designing Buildings.
* BSRIA definitions.
* BSRIA.
* DC offset.
* Harmonics.
* Interharmonics.
* Notching.
* Power.
* Voltage.
* Watt.

[[Category:DCN_Definition]] [[Category:DCN_Guidance]] [[Category:Definitions]]

Neutral conductor sizing for commercial loads - Revision history

Designing Buildings: Created page with "[https://www.bsria.com/uk/product/vBGLrE/bsria_power_quality_guide_ag_22000_a15d25e1/ BSRIA Power quality guide (AG 2/2000)] was written by C C Pearson and V Uthayanan and publis..."