Construction Industry Model Arbitration Rules CIMAR - Revision history

Designing Buildings at 08:41, 24 November 2020

2020-11-24T08:41:29Z

← Older revision		Revision as of 08:41, 24 November 2020
Line 47:		Line 47:
	* [http://www.constructionarbitrators.org/ Society of Construction Arbitrators]		* [http://www.constructionarbitrators.org/ Society of Construction Arbitrators]

−	[[Category:~~Organisations~~]] [[Category:~~DCN_Organisation~~]] [[Category:~~Publications_/_reports~~]] [[Category:~~Standards_~~/~~_measurements~~]] [[Category:~~DCN_Standard~~]]	+	[[Category:DCN_Definition]] [[Category:DCN_Guidance]] [[Category:DCN_Standard]] [[Category:Organisations]] [[Category:Publications_/_reports]] [[Category:Standards_/_measurements]]

Editor at 11:19, 10 October 2016

2016-10-10T11:19:44Z

← Older revision		Revision as of 11:19, 10 October 2016
Line 36:		Line 36:
	* JCT.		* JCT.
	* Joinder.		* Joinder.
−	* Pendulum arbitration.
	* NEC3.		* NEC3.
	* NEC contract change management systems.		* NEC contract change management systems.
	* NEC early contractor involvement.		* NEC early contractor involvement.
		+	* Pendulum arbitration.
		+	* Provisional relief.
	* Target cost.		* Target cost.

Line 46:		Line 47:
	* [http://www.constructionarbitrators.org/ Society of Construction Arbitrators]		* [http://www.constructionarbitrators.org/ Society of Construction Arbitrators]

−	[[Category:Organisations]] [[Category:Publications_/_reports]] [[Category:Standards_/_measurements]]	+	[[Category:Organisations]] [[Category:DCN_Organisation]] [[Category:Publications_/_reports]] [[Category:Standards_/_measurements]] [[Category:DCN_Standard]]

Designing Buildings at 11:08, 5 July 2016

2016-07-05T11:08:39Z

← Older revision		Revision as of 11:08, 5 July 2016
Line 3:		Line 3:
	The Construction Industry Model Arbitration Rules (CIMAR) were produced by the Society of Construction Arbitrators and introduced following the 1996 Arbitration Act. The rules have no statutory status and depend upon voluntary incorporation into contracts. They have been widely used for dispute resolution in the industry since being adopted as the standard by the Joint Contracts Tribunal (JCT).		The Construction Industry Model Arbitration Rules (CIMAR) were produced by the Society of Construction Arbitrators and introduced following the 1996 Arbitration Act. The rules have no statutory status and depend upon voluntary incorporation into contracts. They have been widely used for dispute resolution in the industry since being adopted as the standard by the Joint Contracts Tribunal (JCT).

−	According to CIMAR: ~~‘The~~ objective of the rules is to provide for the fair, impartial, speedy, cost-effective and binding resolution of construction disputes, with each party having a reasonable opportunity to put his case and to deal with that of his opponent.’	+	According to CIMAR: 'The objective of the rules is to provide for the fair, impartial, speedy, cost-effective and binding resolution of construction disputes, with each party having a reasonable opportunity to put his case and to deal with that of his opponent.'

−	Once the arbitrator has been appointed under these rules, the parties may not, without the ~~arbitrator’s~~ agreement, amend the rules or impose procedures in conflict with them. The rules apply where:	+	Once the arbitrator has been appointed under these rules, the parties may not, without the arbitrator's agreement, amend the rules or impose procedures in conflict with them. The rules apply where:

	* A single arbitrator is to be appointed.		* A single arbitrator is to be appointed.
Line 44:		Line 44:
	=== External references ===		=== External references ===

−	* JCT - [http://www.jctltd.co.uk/docs/JCT_CIMAR%202011.pdf CIMAR]
	* [http://www.constructionarbitrators.org/ Society of Construction Arbitrators]		* [http://www.constructionarbitrators.org/ Society of Construction Arbitrators]

	[[Category:Organisations]] [[Category:Publications_/_reports]] [[Category:Standards_/_measurements]]		[[Category:Organisations]] [[Category:Publications_/_reports]] [[Category:Standards_/_measurements]]

Editor: Created page with "Arbitration is a private, contractual form of dispute resolution. It provides for the determination of disputes by a third party arbitrator or arbitration panel, selected by the ..."

2016-01-29T13:05:12Z

Created page with "Arbitration is a private, contractual form of dispute resolution. It provides for the determination of disputes by a third party arbitrator or arbitration panel, selected by the ..."

New page

Arbitration is a private, contractual form of dispute resolution. It provides for the determination of disputes by a third party arbitrator or arbitration panel, selected by the parties to the dispute.

The Construction Industry Model Arbitration Rules (CIMAR) were produced by the Society of Construction Arbitrators and introduced following the 1996 Arbitration Act. The rules have no statutory status and depend upon voluntary incorporation into contracts. They have been widely used for dispute resolution in the industry since being adopted as the standard by the Joint Contracts Tribunal (JCT).

According to CIMAR: ‘The objective of the rules is to provide for the fair, impartial, speedy, cost-effective and binding resolution of construction disputes, with each party having a reasonable opportunity to put his case and to deal with that of his opponent.’

Once the arbitrator has been appointed under these rules, the parties may not, without the arbitrator’s agreement, amend the rules or impose procedures in conflict with them. The rules apply where:

* A single arbitrator is to be appointed.
* The seat of the arbitration is in England, Wales or Northern Ireland.

The rules deal with the following areas:

* Beginning and appointment.
* Joinder.
* Particular powers.
* Procedure and evidence.
* Form of procedure and directions.
* Short hearing.
* Documents only.
* Full procedure.
* Provisional relief.
* Default powers and sanctions.
* Awards and remedies.
* Costs.

= Find out more =

Related articles on Designing Buildings Wiki:

* Alternative dispute resolution.
* Arbitration.
* Arbitration Act.
* Causes of construction disputes.
* Dispute resolution boards.
* JCT.
* Joinder.
* Pendulum arbitration.
* NEC3.
* NEC contract change management systems.
* NEC early contractor involvement.
* Target cost.

=== External references ===

* JCT - [http://www.jctltd.co.uk/docs/JCT_CIMAR%202011.pdf CIMAR]
* [http://www.constructionarbitrators.org/ Society of Construction Arbitrators]

[[Category:Organisations]] [[Category:Publications_/_reports]] [[Category:Standards_/_measurements]]