- Project plans
- Project activities
- Legislation and standards
- Industry context
Last edited 18 Jan 2018
Compressive Strength of Expanded Polystyrene
 Compressive Strength of Expanded Polystyrene (EPS) for Civil Engineering Applications explained.
EPS has been successfully used as a light weight fill material in Civil Engineering applications for many years. However there is conflicting information in the market place regarding the compressive strength properties of EPS. So what is fact and fiction?
 Short Term Compression:
The EPS market has traditionally quoted 1% compressive strength figures in literature, data sheets and websites which are based on short term rapid load tests. These tests are short term compression laboratory tests involving a load being applied and then removed after a short period of time. See Table 1.
This data obtained from a 1994 Transport Research Laboratory Report applies only to embankments and landscaping applications NOT civil engineering applications with long term imposed loads. The report has been superseded by BS EN14933:2007 Thermal insulation and light weight fill products for civil engineering applications — Factory made products of expanded polystyrene (EPS) — Specification.
 Long Term Compression:
For civil engineering applications BS EN14933:2007 recommends that engineers use 2% compressive stress figures to calculate the required grade of EPS material. These figures are extrapolated in accordance with BS EN1606:2013 to provide 50 year long term data reflecting the actual compressive creep that would take place over the life span of the EPS once installed and carrying the maximum imposed load. See Table 2.
 Product Classification:
EPS products are also classified into types based on the 10% compressive strength figures, an extract of Table C.1 - Classification of EPS Products is shown in Table 3 below taken from BS EN14933:2007.
 Product Comparison:
The Construction Products Regulations (CPR) makes the technical specification of construction products transparent which means manufacturers must comply with harmonised standards such as BS EN14933:2007 when placing products on the market.
Table 4 compares the physical properties of some of the most popular EPS products manufactured to BS EN14933:2007 and sold in the UK for use in civil engineering applications. For the purpose of this comparison we have used the Compressive Strength at 10% figure and Nominal Density (kg/m3) to show the products are identical in terms of performance*
As you can see from the comparison table the products are identical in terms of performance as per the requirements of BS EN14933:2007 and therefore engineers can specify like for like product without concern.
- Data obtained from RIBA Product Selector, manufacturers Declaration of Performance certificates and manufacturers websites.
--Styrene Packaging and Insulation Ltd 11:31, 18 Jan 2018 (BST)
Featured articles and news
The BREEAM Sustainability Champion is changing to the Advisory Professional - here's what you need to know.
A fresh round of job-cuts takes the total number of redundancies to over 1,000.
Read our introductory article to the completion date in construction contracts.
Almost 90% of freight in London is moved by road. The River Thames could add much needed extra capacity.
National Infrastructure Commission warn that large infrastructure projects are at risk of falling behind.
The quality of Cambridge owes as much to its open spaces as to its architectural uniqueness.
If events occur that cause the completion of the works to be delayed then these may be compensation events.
BSRIA's new Building MOTs Scheme is designed to provide guidance on the next steps after compliance.
At an ICE discussion, the focus was on delivering a Northern Infrastructure Strategy based on opportunity for all.
The Considerate Constructors Scheme officially launch the new Ultra Site status for contractors and supply chains.